MAXTOR ATA HARD DRIVE INSTALLATION GUIDE
3.
Immediately after the function key message appears, press the indicated
key to enter Setup. Within the BIOS Setup utility, navigation is limited to
keyboard commands. The active function keys are usually Esc, Tab, Page Up,
Page Down, Enter, +, -, spacebar, number, and arrow keys. The BIOS Setup
utility usually has keyboard instructions located somewhere on the screen.
4.
Upon entering Setup, highlight the Auto-Detect IDE HDD/Hard Drives option
(if displayed) and press Enter. This will allow the system to automatically
detect the devices on your primary and secondary ATA channels. If there is no
Auto-Detect option available, choose Standard CMOS.
If you are unable to locate the function key message to enter CMOS Setup or are
experiencing difficulty with hard drive detection in the BIOS, refer to your system
manual or contact the system manufacturer.
5.
After the hard drives are detected, save the settings.
6.
Exit Setup and power off the system.
PAGE 13