Fireplace Installation; Operation - Dimplex DF3003 Owner's Manual

Fireplace Installation

1. make sure the unit's main
on/off switch is switched off
(refer to operating instruction
section).
2. Plug the unit into a 15
Amp/120 Volt outlet. If the
cord does not reach, you may
use an extension cord rated
for a minimum of 1875 Watts.
3. Push the fireplace into the
opening being careful not
to damage the base of the
mantel or cabinet so that
the fireplace is flush with the
mantel or cabinet.

Operation

Figure 3
D
A. Manual On/Off Switch
The fireplace has a manual
power on/off switch located on
the control panel of the fireplace.
Toggle the switch to turn the
fireplace on and off.
10
B C
4. Level the unit with shims if
necessary (not provided).
5. Install the trim onto the
fireplace (refer to trim
installation instructions).
WARNINg: Ensure the
power cord is not installed so
that it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
B. Light Dimmer
Turn the flame brightness control
knob to increase or decrease
the brightness of the flame and
embers.
A
www.dimplex.com