Selecting Options; Time Remaining - Asko D5644 User Manual

Mixed wash
This dishwashing program is used when you have lightly soiled
dishes in the upper basket and heavily soiled dishes in the lower
basket. This program adds a prewash and has a longer program
time than Lower half.
Rinse & Dry
This program consists of a rinse with heating and drying. This is a
suitable program if, for example, you plan to make jam and want
to rinse and heat clean glass jars.
Rinse & Hold
Use to rinse dishes while you wait for the dishwasher to become
fully loaded.

SELECTING OPTIONS

To select an option, press one of the option buttons. The field
under the button lights when the option is activated. The available
options depend on the selected program. Once you have started
the program, the options you selected are saved for the next time
you use the same program. An exception is the Delayed start
option.
High temperature
Activate this option for improved dishwashing results. The machine
then uses a higher temperature for the main wash.
If you want to use the lower temperature, press again so that the
field under the button turns off.
You can vary the temperature as shown below:
Heavy wash: 140 °F (60 °C) / 160 °F (70 °C)
Normal wash: 115 °F (45 °C) / 150 °F (65 °C)
Daily wash: 140 °F (60 °C)/150 °F (65 °C)
Quick wash: 85 °F (30 °C) / 140 °F (60 °C)
Super Quick: 85 °F (30 °C) / 140 °F (60 °C)
Delicate wash: 105 °F (40 °C) / 120 °F (50 °C)
Eco wash: 120 °F (50 °C) / 140 °F (60 °C)
Upper half: 130 °F (55 °C) / 150 °F (65 °C)
Lower half: 130 °F (55 °C) / 150 °F (65 °C)
Mixed wash: 130 °F (55 °C) / 150 °F (65 °C)
Long dry
A higher temperature in the final rinse and a longer drying phase
improves the drying result if you activate the Long dry option. This
causes a slight increase in energy consumption. This option can be
used with all programs except Time program, Rinse & Dry, and
Rinse & Hold.
If you want a program with Short dry, press again so that the field
under the button turns off.
Delayed start
When you select Delayed start, the dishwasher will start 1-24
hours after you press the Start/Stop button.
1 Press the button once to activate Delayed start. Press the
button several times – or hold it in – to set the desired number
of hours.
2 Press Start/Stop and the dishwasher counts down 1 hour at a
time and starts after the selected delay.
Press and hold Start/Stop for three seconds if you want to cancel
the Delayed start option.
NOTE!
Remember to press the Start/Stop button to start the program.
Press the option button several times – or hold it in – to set the
desired program time for Time program. You can choose a
program time between 30 minutes and 3 hours.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
The display flashes three times with the remaining time to indicate
that the program has started.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.

TIME REMAINING

Once you have selected a program and options, the display
indicates how long the program took the last time it was used.
Once you have started the dishwasher, the display indicates how
much program time remains. The remaining time is updated after
the water for the final rinse has been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature, and other factors.
While the program is running, the time counts down and the
remaining program time is shown on the display. The remaining
time is shown, for example, as 1:15, which means the program will
run for another 1 hour and 15 minutes.
Customer Care Center 1-800-898-1879
www.askousa.com
Set time
(the door
9