convertIng froM natural gas to ProPane/lP gas
for use When converting Model (v)P325(B)
This conversion kit must be
installed by a qualified service
person.
Read these instructions completely before
installing this conversion kit.
Before proceeding, make sure the gas con-
trol valve is in the OFF position, all electrical
power to the appliance is OFF, and the fire-
place is cool to the touch.
CAUTION: The gas supply
shall be shut off prior to dis-
connecting the electrical power
before proceeding with the
conversion.
Parts included with this kit:
Part No.
Description
108805-01 Instruction Sheet
108085-02 Pilot Orifice LP
901065-09 Main Burner Orifice LP
901066-02 Air-Mixer Brass LP
106380-01 Gas Valve Regulator
108808-02 Conversion Label, English
108809-02 Conversion Label, French
106080-01 Conversion Information Label 1
Tools Required:
• 7/8" Open End Wrench or Adjustable
Wrench
• 3/4" Open End Wrench or Adjustable
Wrench
• 3/8" Deep Socket Drive
• Torx T20 or Slotted Screwdriver
• 5/32" Allen Wrench
• #2 Short Phillips Screwdriver
• Thread Sealant (Resistant to Propane/LP )
InstallatIon InstructIons for
PcBM-325 conversIon kIt
vented Decorative fireplace
www.desatech.com
ACCessINg FIrePlACe
You may access burner system through open-
ing in front of unit.
1. Remove front glass panels (if installed).
This will keep them from being damaged.
To remove, partially open doors. Press
up on upper spring clip of one door panel
with a screwdriver until outer top pivot pin
is free of clip (see Figure 1). Repeat with
second door panel. Place glass panels
safely out of your work area.
2. Slide open screens and tuck inside outer
pockets on firebox.
3. Remove front refractory access panel by
lifting up and angling out of firebox open-
ing (see Figure 2, page 2).
Depress Spring Clip to
Release Pivot Pin
Qty.
1
1
1
1
1
1
Fold Bi-Fold
Door After
1
Releasing
Spring Clip
and Slide
Door Out
of Upper
Track
Remove Bottom Pin From
Pivot Plate While Sliding Door
Out of the Upper Track
Figure 1 - Removing Glass Doors
Spring
Clip
Pivot
Plate
Need help?
Do you have a question about the PCBM-325 and is the answer not in the manual?
Questions and answers