Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that
will enable you to obtain replacement parts or accessory items when needed. Keep it with your other important papers.
This fireplace is approved for use as a wood burning fireplace or for use with a vented gas log approved to ANS Z21.60, Z21.84 or
RGA 2-72 standards or for use with a vent-free gas log heater approved to ANS Z21.11.2 standard. A DESA hood must be installed
when using a vent-free gas log heater (see Accessories, p. 10).
WARNING: ALWAYS LEAVE GLASS DOORS FULLY OPENED
OR FULLY CLOSED WHEN OPERATING THIS FIREPLACE.
ALL DIMENSIONS IN THIS MANUAL ARE IN
INCHES UNLESS OTHERWISE SPECIFIED
DESA INTERNATIONAL
2701 INDUSTRIAL DRIVE
P.O. BOX 90024
BOWLING GREEN, KY 42102-9004
www.desatech.com
Models: 36WL Circulating (Louvered)
36WIL Circulating (Louvered) Fully Insulated
36WS Non-Circulating (Smooth Face)
36WIS Non-Circulating (Smooth Face) Fully Insulated
SAVE THIS BOOK
BAJA II
36" Wood Burning Fireplace
P/N 107180-01
REV B
2/01
Advertisement
Table of Contents
Related Manuals for FMI BAJA II 36WIL
Summary of Contents for FMI BAJA II 36WIL
-
Page 1: Installation Instructions
BAJA II 36” Wood Burning Fireplace Models: 36WL Circulating (Louvered) 36WIL Circulating (Louvered) Fully Insulated 36WS Non-Circulating (Smooth Face) 36WIS Non-Circulating (Smooth Face) Fully Insulated INSTALLATION INSTRUCTIONS SAVE THIS BOOK This book is valuable. In addition to instructing you on how to install and maintain your appliance, it also contains information that will enable you to obtain replacement parts or accessory items when needed. -
Page 2: Table Of Contents
CONTENTS INTRODUCTION --------------------------------------------------------------------------------- PG. 2 SELECTING LOCATION --------------------------------------------------------------------------------- PG. 2 3. MINIMUM CLEARANCES --------------------------------------------------------------------------------- PG. 2 4. FRAMING AND INSTALLING --------------------------------------------------------------------------------- PG. 3 5. HEARTH EXTENSION --------------------------------------------------------------------------------- PG. 3 6. OUTSIDE AIR KIT INSTALLATION --------------------------------------------------------------------------------- PG. 4 7. FAN KIT ASSEMBLY --------------------------------------------------------------------------------- PG. -
Page 3: Introduction
This fireplace is intended to be used as a decorative appliance and is not intended to be used to heat the home. FOR YOUR SAFETY • Do not store or use gasoline or any other flammable This wood burning fireplace complies with UL 127 vapors or liquids in the vicinity of this or any other standard as a FACTORY BUILT FIREPLACE. -
Page 4: Hearth Extension
STEP 5: Before securing fireplace to prepared framing, the extension from shifting and seal the gap between the fireplace ember protector (provided), must be placed between the hearth frame and hearth extension with a non-combustible material extension (not supplied), and under the bottom front edge of (see figure 3). -
Page 5: Fan Kit Assembly
FAN KIT ASSEMBLY: VCBK3E ASSEMBLING AND INSTALLING THE DOUBLE A Fan Kit is optional (for Models W36C & IW36C only) with WALL CHIMNEY SYSTEM this fireplace. Use of blowers or fans other than manufactured by DESA voids the warranty. Fan is operated by simply Each double wall chimney section consists of a galvanized pressing the rocker switch in the lower right corner of the outer pipe, a stainless steel inner flue pipe and a wire spacer. - Page 6 2. Chimney weight above offset rests on return elbow. FIRESTOP SPACERS: (V3600FS-8DM) Straps must be securely nailed to rafters or joists (see Firestop spacers are required at each point where the chimney figure 9, details a & b). penetrates a floor space. Their purpose is to establish and 3.
-
Page 7: Terminations
FLASHING INSTALLATION: (V6F-8DM or V12F-8DM) that can be used for flashing or chase and ET-8DM, ETO- Determine the flashing to be used with the roof-opening chart. 8DM, ETL-8DM and ETLO-8DM for chase style termination Slide flashing over pipe until base is flat against roof. Replace only. -
Page 8: Mantels
10 FOOT RULE: All flue gas outlet of chimney termination must extend a minimum of 3 feet in height above the highest point where it TOP VIEW OF FIREPLACE passes through the roof and must be at least 2 feet above the highest point of the roof that is within a horizontal distance of 10 feet (see figure 18). -
Page 9: Gas Line Installations
IMPORTANT: The glass must be allowed to warm slowly and evenly. The tempered glass will withstand a gradual temperature rise to 550 degrees Fahrenheit, which is more than a normal fire will generate. Such materials as pitch/wax laden logs, very dry mill end lumber, and large amounts of paper or cardboard boxes can create an excessively hot fire and should not be burned in this fireplace. -
Page 10: Damper Operation
DAMPER OPERATION: The damper handle to open and close the damper blade is WARNING: Risk of fire! Replace grate with DESA located inside the firebox at the center towards the back wall. model 107001-01 grate only. This grate has been designed Pushing the handle back in the keyway slot will free the to keep the operation of your fireplace safe and efficient. -
Page 11: Replacement Parts
REPLACEMENT PARTS ACCESSORY PARTS For more information, visit www.desatech.com...
Need help?
Do you have a question about the BAJA II 36WIL and is the answer not in the manual?
Questions and answers