200 miles. At a minimum, these vehicles require sig- nifi cant modifi cation, such as the use of an aftermarket product, to make them towable. The availability of a Demco Tow Bar Base Plate does not imply that these vehicles can be modifi ed or that there is an aftermarket product available.
Page 3
5. Remove two nuts holding facia to fender on each side by going through wheel well opening. 2. Remove screws from wheel well to facia on each side. 6. Remove two plastic push fasteners from bottom side 3. Remove plastic wheel well extension, two plastic push of bumper and unplug fog light.
Page 4
9. Slide base plate up from bottom and line up tight against front frame bracket as shown in picture. 12. Remove one front sub-frame bolt from each side, for Clamp in place. bottom brace (see picture). Install long end of brace and refasten long sub-frame bolt.
Please list the specific source of information prompting this purchase. After purchasing this product, do you see any needed product improvement? If yes, what improvement? What other products would you like to see DEMCO offer? Comments Owner’s Name: Mailing Address:...
Page 7
Boyden, IA 51234 We reserve the right to change or improve the design (712) 725-2311 of any Demco product, including but not limited to state of the art changes, without assuming any obligation to 3. Repair or Replacement Procedure: modify any product previously manufactured.