Electrolux E36GC65ESS - 30"""" Drop-in Gas Cooktop Use & Care Manual page 21

CLEANINGT BURNERIIGNBTORS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Under certain cooking or cleaning conditions, your cooktop igniters may become
coated with or corroded by food deposits, splattered grease or cleaning agents.
This condition can cause erratic or continuous sparking. Keeping the igniters clean
and dry will help to reduce this problem. To avoid unnecessary and costly service
calls, the homeowner should perform periodic cleaning of the igniters.
To clean the igniters:
,
2.
Be sure burners are cool to the touch. Remove the grate, burner cap and
burner heads.
Brush completely around the igniter, including over and under the edge of the
metal cap and base. Use care while cleaning here. Parts of the igniter are
porcelain and can be fragile.
3. DO NOT USE WATER when cleaning the igniters. If a liquid must be used to
clean the igniter effectively, use only a small amount of rubbing alcohol.
4. After cleaning, reinstall the burner ring, burner cap and grate. Make sure the
brass burner ring is properly seated into the burner base.
5. Test the burners, tf erratic clicking is still present, make sure the igniter is
completely dry.
tf the unit still exhibits problems after drying, please phone the Electrolux Customer
Service Department for further assistance.
Your gas grill will develop greasy areas as a normal result of use. Clean all greasy
surfaces, including the heat control channel, with mild soap and a cloth.
Do not wash the U-shaped burner in a dishwasher. Clean the surface of the
U-shaped burner with soapy water and a soft bristle brush. Do not submerge the
burner in water. Rinse under water and dry thoroughly.
During cleaning, some material may get clogged in the holes of the gas tubing. Use
a paper clip or needle to free all plugged hobs of lose material. Dump out all
cleaning materials from inside the U-shaped burner before reassembling the
appliance.