Meridian DSP8000 User Manual page 40

TROUBLESHOOTING
Drive units move when the speaker is switched on or
off
• This is normal as the speaker active electronics settle.
Configuring the DSP8000 loudspeaker does not have
any effect
Make sure that you are configuring the DSP8000 loudspeaker used as the
master digital loudspeaker in the system. This determines the configuration
of all digital loudspeakers in the system.
Unit stays in standby
• Check that it is connected correctly.
• Turn the system on from another Meridian product in the system.
Only the master loudspeaker plays
• Check the S5 cables are connected correctly.
Sound is odd or mono
• Check that the DSP8000 loudspeakers are correctly configured as Left
and Right respectively.
The yellow indicator flashes or stays on
This indicates that DSP clipping is occurring.
Brief flashes indicate occasional clipping which will not be audible.
If the indicator stays on for long periods this may indicate a fault in the
configuration of your system, and you should contact your Meridian dealer.
35