Rear Panel - M-Audio KEYRIG 25 User Manual

Rear Panel

10. Power Switch – This switch powers the unit on and off.
11. Sustain Pedal Input – Connect your sustain pedal's 1⁄4" connector to this jack. There is no need to worry about the polarity of the
pedal—the keyboard detects the sustain pedal polarity by auto-sensing the pedal's orientation during startup.
12. MIDI Output – Connect this output to the input of a MIDI device using a standard 5-pin MIDI cable. By default, all MIDI data
generated by KeyRig 25 is sent out through this MIDI output as well as through the USB connection (if available). However, if
KeyRig 25 is connected to your computer via USB, it is possible to reconfigure this port so that it appears as a completely separate
MIDI output port to your music software.
Refer to the "Using KeyRig 25" section of this manual to learn how to engage "MIDI Out from USB" mode.
13. USB Connector – Connect a USB cable from this output to the host computer's USB port. When using the USB connection,
KeyRig 25 is powered by the host computer and a power adapter is not required.
14. Power Jack (9V DC, 500 mA) – Connect an optional 9V DC, 500mA external power supply to this jack. A power supply is only
necessary if KeyRig 25 is being used without a computer or if the computer is not able to provide adequate bus power to the
controller.
The optional power adapter can be ordered from www.m-audio.com
IMPORTANT: The KeyRig 25 keyboard is "bus-powered" by your computer through the USB connection. Only use a power
adapter if your computer cannot provide adequate power to the controller or if you are using KeyRig 25 without a computer.
KeyRig 25 User Guide
�� �� �� �� ��
|
7