Table of Contents
Advertisement
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges, bal-
ancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
3/16-24 x 3/8" SLOTTED PHILLIPS HEAD
SCREW (3)
PLASTIC WASHER (3)
FELT WASHER (3)
FAN BLADE
Figure 5
BLADE FLANGE
8. Turn the fan assembly upside down in preparation
for mounting the fan blade assemblies.
NOTE: Take care not to scratch fan housing when
installing blades.
9. Rotate the motor hub until the flange screw hole is
visible through one of the slots in the switch hous-
ing plate. Loosely attach one blade assembly to the
motor hub using two 1/4-20 x 7/16" Phillips oval
head flange screws (Figure 6). Make sure the
screws are NOT tightened. Repeat this procedure
for the other four blade assemblies.
10. The blade flanges have an interlocking feature that
must be fully engaged before tightening the
screws. Make sure all the flanges are properly
engaged and then tighten the flange screws. If one
of the flanges does not seat properly on the motor
hub, loosen the adjacent flange screws, re-engage
and reseat the flanges, then tighten the screws
again.
SWITCH HOUSING
PLATE
MOTOR HUB
Figure 6
11. Engage the connector of the switch housing
assembly with the motor connector (Figure 7).
The two connectors are keyed and color-coded
and must be mated correctly (color-to-color)
before they can be engaged. Make sure the con-
nector latch closes properly.
BLADE
FLANGE
1/4-20 x 7/16" PHILLIPS OVAL
HEAD FLANGE SCREWS
(INSTALL THROUGH SLOT IN
SWITCH HOUSING PLATE)
5
SWITCH
HOUSING
ASSEMBLY
Figure 7
12. Remove the four mounting screws from the switch
housing plate. Attach the switch housing to the
switch housing plate using the four mounting screws.
NOTE: Do not pinch wires between the switch
housing assembly and the switch housing plate.
SWITCH HOUSING
ASSEMBLY
Figure 8
13. You have now completed the assembly of your
new ceiling fan. You can now proceed with hang-
ing and wiring your fan.
Electrical Requirements
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked acceptable for
fan support, and use screws supplied with outlet
box. Most outlet boxes commonly used for support
of light fixtures are not acceptable for fan support
and may need to be replaced. Consult a qualified
electrician if in doubt.
The outlet box must be securely anchored and capa-
ble of withstanding a load of at least 50 pounds.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
WARNING
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
SWITCH HOUSING
ASSEMBLY
MOTOR
CONNECTOR
MOUNTING
SCREWS (4)
Advertisement
Table of Contents
