Cornelius 2306 Installation Instructions

For installing scotsman model cm450, 500, & 650 series ice makers on remcort model db200 series ice/drink dispenser

Download this manual

INSTALLATION INSTRUCTIONS

For installing Scotsman Model CM450, 500, & 650 Series Ice Makers on Remcort Model DB200 Series Ice/

Drink dispenser.

1. Bin Level Control

Locate and drill three (3) 5/16"diameter holes (Ref. Fig. 1).

Install mounting clamps.

2. Seal ice maker to top of Dispenser as follows:

Run a bead of RTV on the dispenser cover around the outline of the ice maker and inside edge of cov-

er opening.

Set ice maker onto cover and install bin level thermostat capillary tube in clamps and tighten screws

(Ref. Fig 1). Position ice maker as shown.

Wipe away excess RTV.

3. Secure ice maker to Dispenser with mounting brackets as show. Drill holes and install sheet metal screws

provided into ice maker cabinet and dispenser cover. Screws must not interfere with ice maker compo-

nents.

4. Install adhesive backed gasket strip to removable lid, and install with screw provided.

5. Follow the manufacturer' s instructions to complete the installation of the ice maker. Bin level thermostat

capillary tube must not interfere with agitator.

91933

KIT, P/N 2306

IMI CORNELIUS INC.

One Cornelius Place

Anoka. MN 55303-6234

Telephone (800) 238--3600

Facsimile (612) 422--3246

12/9/96

Page 1: Installation Instructions
IMI CORNELIUS INC. One Cornelius Place Anoka. MN 55303-6234 Telephone (800) 238--3600 Facsimile (612) 422--3246 INSTALLATION INSTRUCTIONS KIT, P/N 2306 For installing Scotsman Model CM450, 500, & 650 Series Ice Makers on Remcort Model DB200 Series Ice/ Drink dispenser. 1. Bin Level Control Locate and drill three (3) 5/16”diameter holes (Ref.
Page 2 ROUTE ICEMAKER BIN LEVEL THERMOSTAT CAPILLARY TUBE AS SHOWN. INSTALL ON HOPPER AS SHOWN IN FIG. 1 ICEMAKER TO BE FLUSH WITH BACK EDGE OF COVER. APPLY RTV AROUND INSIDE OF ICEMAKER OUTLINE ON DISPENSER COVER TO FORM A SEAL. ADD ADHESIVE BACKED GAS- KET STRIPS TO REMOVABLE LID.
Page 3 ICEMAKER TOP- VIEW FRONT WALL OF HOPPER THERMOSTAT CAPILLARY TUBE LOCATE AND ADD CLAMP HOLE IF NEEDED TO RETAIN CAPILLARY TUBING 4--5/8 15” 1” DRILL 5/16 DIA. HOLES FOR 8--32 WELD NUT INSERT 8-32 WELL NUTS INTO 5/16 DIA. HOLES, TIGHTENING SCREWS WILL SECURE 1--5/8 CAPILLARY TUB-...