Lightolier KUBIK LIGHT LINEAR FLUORESCENT LUMINAIRE Instructions For Installation

A. POWER SUPPLY:
1. Follow the instructions sheet on the appropriate power
supply. (See series ISSL003)
B. COVER: (if required)
1. Carefully pull the lamp holder housing out from the
channel. (Fig.1)
2. Insert the end of a small slot screwdriver into the slot.
(Fig.2)
3. Lift the cover gently all along the channel. (Fig.2)
4. Ajust ball plunger pressure as needed. (Fig.4)
To reinstall the cover
1. Align one end of the cover with the block in the channel.
(Fig.3)
2. Press the cover along the length of channel. (Fig.3)
C. DIRECTION:
1. Follow the instructions Sheet No. ISSL003H.
D. LAMP:
(does not apply to the extended blank model no. SL003F)
2" and 2-3/4" model
1. Carefully pull the lamp holder housing out of the channel.
(Fig.1)
2. Align the pins of the lamp with the lamp holder(s), and
push in until they click. (Fig.5)
13-7/8" model
1. Align the pins of the lamp with the lamp holder, and push
in until they click. (Fig.6)
2. Gently push the stem outward and align the of the lamp
with the lamp holder, and push together until they
click. (Fig.6)
Linear fluorescent lamp T5 miniature, BI-PIN base
INSTRUCTION SHEET INSTRUCTION SHEET INSTRUCTION SHEET
INSTRUCTION SHEET INSTRUCTION SHEET
INSTRUCTION FOR INSTALLATION KUBIK LIGHT
LINEAR FLUORESCENT LUMINAIRE
BLANK EXTENSION

LAMP

HOLDER
SCREWDRIVER
BLOCK

COVER

CHANNEL
LAMP
HOLDER
PINS
STEM
PINS
IS:SL110A
04-05/Rev-03
CHANNEL
FIG.1
COVER
FIG.2
CHANNEL
SLOT
BALL
LOCK
FIG.3 FIG.4
LAMP
HOLDER
FIG.5
LAMP
LAMP HOLDER
LAMP
FIG.6