Table of Contents
Advertisement
ON SCREEN DISPLAY (OSD) ADJUSTMENT
MAIN MENU
To start adjustment press the MENU button. The OSD window opens up at the centre of
the screen and displays the main menu shown below, If you press the MENU button
while the window is open the DT3131 E will either close the OSD window or ask whether
you wish to save your new settings.
The screen displays the current H-SYNC and V-SYNC values and the mode number in
the bottom right corner. The "NOT SUPPORTED'
message will appear if the computer's
current display mode is not supported. In this case the SAVE lamp will also blink. After
several seconds the display will switch off.
If the "NOT SUPPORTED"
message appears your computer may be set to a video mode
that is not supported by the DT3131 E. Please be sure to select a supported mode at your
computer. (Refer to "Video Modes" on page 33). If necessary refer to your computer's
operation manual for information about how to make video settings at your computer.
If you change one or more values and then press the MENU button to exit the screen will
display the SAVE SETTINGS
window. To save settings select YES. For more details
refer to the explanation of the SAVE SETTINGS window (page 26).
18
Advertisement
Table of Contents
