Advertisement
n
NEVER REMOVE THE REAR COVER !
contains high voltage components.
THE POWER POINT SHOULD BE CLOSE TO THE MONITOR AND
EASILY ACCESSIBLE !
n
INSTALL THE UNIT IN AN SUITABLE ENVIRONMENT !
DO NOT expose this monitor to rain or moisture to prevent electric shock or fire hazard.
is designed to be used in an office or business environment
DO NOT subject the unit to vibrations, dust, or corrosive gases.
n
KEEP IN A WELL VENTILATED PLACE !
DO NOT cover this monitor or place anything against any sides (not only the top, right and left side
but also the rear and bottom side) of unit.
cover to prevent the temperature from rising.
n
KEEP AWAY FROM HEAT SOURCES !
AVOID placing the unit in direct sunshine or near a heating appliance.
n
BE CAREFUL OF MAGNETIC FIELDS !
DO NOT place a magnet, loudspeaker system, floppy disk drive, printer, or anything which will
generate magnetism near the unit.
n
BE CAREFUL OF GENERATED MAGNETISM !
After the power has been turned on or "DEGAUSS" button has been pressed, the CRT is
demagnetised for approximately IO seconds. This generates a strong magnetic field around the
front cover which may affect the data stored on magnetic tape or disks near the front cover.
such magnetic recording equipment and tapes/disks away from this unit.
n
AMBIENT ILLUMINATION
Avoid direct rays of the sun or room lighting onto the CRT screen in order to prevent eye fatigue
n
THE ENCLOSED POWER CORD MUST BE USED !
In Europe, a proper European standard approved power cord is to be used with this monitor.
rated current up to 6 A, a type not lighter than HOSW-F 3G 0.75 mm2 or H05WH2-F 3G 0.75 mm*
must be used.
In USA/Canada, use a UL LISTEDKSA LABELLED or CERTIFIED power cord set meeting the
following specifications
Rating: min. 125V, 7A
Length: max. 3.lm
Type: SVT or SJT
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type, 125V, 15A
Failure to do so may cause fire or electric shock hazard.
n
USE ONLY THE CORRECT VOLTAGE POWER OUTLET WITH SAFETY
GROUND CONNECTION !
100 - 120 V for USA, Canada, etc.
200 - 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 I 200 - 240V.)
2
Ventilation holes are provided -at all sides of the rear
A magnetic field may cause blurred colours or distortion of the
This unit
Place
For a
Advertisement
