Hitachi CM1711MET-PCMP User Manual page 9

3. Signal Input Connection
Connect the
Signal Input Connector
to the D-Sub Mini IBpin signal output
terminal of the host computer.
l If the graphics board supplies more than one type of sync. signal, the sync.
signal type will be automatically selected by the monitor, with the priority
shown in the following table.
4. Power On
Turn the
on Power Switch of
Refer to Page 9 'POWER ON/OFF".
NOTICE
n If the picture doesn't appear, turn OFF the power switch, make sure of'the following and wait
Signal Input
Connector
the monitor first, then the computer.
7