Hitachi CP-X268A User's Manual And Operating Manual page 52

OPTION Menu (continued)
Item
AUTO OFF
LAMP TIME
FILTER TIME
MY BUTTON
automatically turn the projector off.
Long (max. 99 minutes)
AUTO OFF
ENABLE
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with no-
signal or an unsuitable signal reaches at the set time, the projector
lamp will be turned off.
If one of the projector's buttons or the remote control buttons is pressed
or one of the commands (except get commands) is transmitted to the
control port during the corresponding time, projector will not be turned off.
Please refer to the section "Turning off the power" (
The lamp time is the time counted after the last resetting. It is
shown in the OPTION menu as the usage time of the lamp.
of the projector displays a dialog. To reset the lamp time, select the
RESET CANCEL
• Please reset the lamp time only when you have replaced the lamp,
for a suitable indication about the lamp.
• For the lamp replacement, see the section "Lamp" (
RESET CANCEL
•
•
Sets the assigned function for the MY BUTTON1 and 2 buttons on
the included remote control.
• RGB1: Sets port to RGB1.
• RGB2: Sets port to RGB2.
• MIU: Sets port to MIU.
• COMPONENT: Sets port to COMPONENT.
• S-VIDEO: Sets port to S-VIDEO.
• VIDEO: Sets port to VIDEO.
• e-SHOT: Displays the e-SHOT menu (
• INFORMATION: Displays INPUT INFORMATION (
• AUTO KEYSTONE EXECUTE: Performs automatic KEYSTONE
37).
correction (
• MY MEMORY: Loads MY MEMORY settings (
• PICTURE MODE: Changes the PICTURE mode (
•
• VOLUME+: Sets the volume up.
• VOLUME-: Sets the volume down.
Description
Short (min. 0 minute = DISABLE)
1
OPTION Menu
AUTO OFF
DISABLE
0
19).
57, 58).
59, 60).
(
53).
45).
31).
27).
43).
(
43