Nikon COOLPIX L105 User Manual page 42

Using the Flash
2
Press m (flash mode) on the multi selector.
• The flash menu is displayed.
3
Press the multi selector H or I to select a
mode, and press k.
• The icon for the selected flash mode is displayed at the
top of the monitor.
• When U (auto) is applied, D disappears after a
few seconds regardless of the monitor settings
(A 100).
• If a setting is not applied by pressing k within a few
seconds, the selection is cancelled.
B
Lowering the Built-in Flash
Push the built-in flash down gently to lower the built-in flash when not in use (A 6).
B
Shooting When Lighting Is Poor and the Flash Is Disabled (W)
• Use of a tripod is recommended to stabilize the camera during shooting and avoid the effects of
camera shake. Set Vibration reduction (A 103) to Off when using a tripod.
• The E is displayed when the camera automatically increases sensitivity to minimize blur caused
by slow shutter speed. Images taken when E is displayed may be slightly mottled.
B
Note on Using the Flash
When using the flash, reflections from dust particles in the air may appear as bright spots in images.
To reduce these reflections, set the flash to W (off).
C
The Flash Lamp
The flash lamp indicates flash status when the shutter-release
button is pressed halfway.
• On: Flash will fire when picture is taken.
• Blinks: Flash charging. Wait a few seconds and try again.
• Off: Flash will not fire when picture is taken.
If the remaining battery level is low, the monitor will turn off
until the flash has finished charging.
30
Flash mode
14 14