Table of Contents
Advertisement
Getting Started
Installing Batteries
Vapor operates on 3 "AAA" batteries (UM-4 or LR03) or a standard 9V
AC center-positive
To install the batteries:
1. Make sure Vapor is OFF.
2. Using a coin, loosen the screws of the battery cover.
3. Insert 3 new "AAA" batteries into the battery compartment as
shown. Do not use rechargeable batteries in Vapor.
4. Close the battery cover and tighten the screws to secure the
battery cover.
Important: While replacing the batteries, the CR2032 backup battery must be kept in Vapor,
if not, you will lose all saved information.
Battery Notice
• Install batteries correctly observing the polarity (+, -) signs to avoid leakage.
• Do not mix old with new batteries.
• Do not use different types of batteries.
• Remove batteries from Vapor when you are not going to use Vapor for a long time.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• Do not short-circuit supply terminals.
Note:
If the sound becomes weak or Vapor suddenly stops working, turn Vapor OFF
for 15 seconds, and then turn it back ON. If the problem persists it may be caused
by weak batteries. Please install a new set of 3 "AAA" batteries and try Vapor
again.
Replacing the Backup Battery
Vapor comes with a backup battery already installed. Before using Vapor, remove
the protective strip from the backup battery by pulling on the plastic tab. To avoid
damage to Vapor from leaky batteries, replace the backup battery at least once a
year.
To replace the backup battery:
1. Make sure Vapor is OFF.
2. Using a coin, loosen the screws of the battery cover.
3. Insert 1 CR2032 size battery as illustrated.
4. Close the battery cover and tighten the screws to secure the
battery cover.
adaptor (not included).
2
300mA
Advertisement
Table of Contents
