Getting Started; Battery Removal And Installation - VTech Switch&Go 5493 Instruction Manual

GETTING STARTED

WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the bottom of the unit, use a
screwdriver to loosen the screw, and then open the battery cover.
3. Remove old battery by pulling
up on one end of the battery.
4. Install 1 new AAA (LR03/
AM-4) battery following the
diagram inside the battery
box. (For best performance,
alkaline batteries or fully Ni-MH
charged rechargeable batteries
are recommended.)
5. Replace the battery cover and
tighten the screw to secure.
4