Getting Started - VTech Chomp-along Dino Instruction Manual

GETTING STARTED

Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the left side of the Dino's body,
use a screwdriver to loosen the screw, and then open the battery
cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 2 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. (For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
4
4