Hunter 44132 Owner's Manual page 30

Features
Menu Options
4. The next Menu option is to set your thermostat's primary span. Use the
or buttons to adjust between 1, 2, or, 3 degrees. Press
been changed or if no changes are necessary. The span setting regulates
when and how long your system will run. The span has been set at the
factory to 1 which will allow the system to turn on.5
below the set temperature and run for .5
set temperature.
Example:
If your thermostat is set to turn on at 72
span setting of 2, your thermostat will activate your furnace at 71
it down when it reaches 73
conditioner will activate at 73
changed to 1, 2, or 3. 1 will shorten your running time while 3 will lengthen
it.
5. Unless you have a multi-stage conventional or heat pump system, there
is no need to change the second stage span. If you do, use the
buttons to adjust between 1, 2, or, 3 degrees. Press
been changed or if no changes are necessary. Secondary span acts the
same as your primary, but it determines when and how long your second
stage heat runs.
6. The last menu option changes your temperature readings between
Fahrenheit and Celcius. Use the
and hit if you need to go back and make a change to a different
Next
menu item, or
30
. For cooling at 72
O
and shut down at 71
O
to be returned to the home screen.
Done/
Home
44067-01 • 10/13/2010
6
F (.05
O
F (.05 C) above or below the
O O
in heat mode, with a
O
with a span of 2, your air
O
. This setting can be
O
or buttons to switch between them
after this has
Next
C) above or
O
and shut
O
or
once this has
Next