Intel; Langchao - EMC CLARiiON AX150 Series Data Book

No.
5
62 IBM xSeries x346 (8840)
63 IBM xSeries x350 (6000R)
64 IBM xSeries x3550 (7978)
65 IBM xSeries x360
66 IBM xSeries x365
67 IBM xSeries x3650 (7979)
68 IBM xSeries x3655 (7943)
69 IBM xSeries x3655 (7985)
7
70 IBM xSeries x370
71 IBM xSeries x3755 (7163)
72 IBM xSeries x3755 (8877)
73 IBM xSeries x3800/x260 (8865)
74 IBM xSeries x3800/x260 (8866)
75 IBM xSeries x3850/x366 (8863)
76 IBM xSeries x3850/x366 (8864), IBM xSeries x3950/x3950E/x460 (8878, 8879)
8
77 IBM xSeries x3850M2 (7141)
8
78 IBM xSeries x3850M2 (7141)
79 IBM xSeries x3850M2 (7233, 7234)
80 IBM xSeries x3950/x3950E/x460 (8872, 8874)
81 IBM xSeries x3950/x3950E/x460 (8878, 8879)
8
82 IBM xSeries x3950M2 (7141)
83 IBM xSeries x3950M2 (7233, 7234)
84 IBM xSeries x440
85 IBM xSeries x445 (8870)
86 IBM xSeries x455 (Itanium 2)
1. Integrated System Management Processor minimum firmware revision BYBT07A
2. EMC VolumeLogix Software required for multiple BladeServers when direct−attached to EMC Symmetrix storage.
3. Support for 4GB fibre channel HBAs requires an IBM SPORE to be submitted to IBM with a request of system BIOS 56A.
4. This system is supported only when the IBM ServeRAID 8i SAS RAID controller (13N227) is installed or when the server is being booted remotely from external storage.
5. Emulex PCI−X and PCI−Express adapters including Qlogic 4Gb PCI−X and PCI−Express adapters are supported in the x346 (8840) only when IBM ServerRAID−7K (71P8642 or
30R8800) is installed with most current firmware and BIOS.
6. This firmware revisions includes support for AIX 5.3 and supports > 12 meg boot images for external boot.
7. For IBM xSeries Servers running Windows 2000 with IBM ServerRaid controller 4M, the ServerRaid Driver must be 6.00 or above for use with EMC PowerPath 3.0 and above. IBM
driver can be downloaded at:
http://www−3.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR−39723
8. Single node support only with Emulex 4Gb HBAs
9. Certain HBA models may be too large to fit into this server's PCI or PCI−X slots. A low−profile HBA may be required. Consult your server owner's guide before
purchasing HBAs for this server.
10. System/Service processor combined microcode Version RH020413 dated 05/22/2002 or later.
11. This server only supports 5 Volt HBAs: QLogic 22XX family (if applicable), QLogic 23XX family, Emulex LP8000, and Emulex LP850 (if applicable).
12. Integrated System Management Processor minimum firmware revision BQ8T21A

Intel

No.
1 Intel SR1400/SE7520JR2, Intel SR2400/SE7520JR2
2 Intel SR4850HW4−M/SR6850HW4−M, Intel SR4850HW4/SR6850HW4

LangChao

03/04/2009
Host System
3, 4
3
8
, IBM xSeries x3950M2 (7141)
3, 4
Host System
IBM
Intel
SE7520JR23.86B.B18.03.00.0, SE7520JR23.86B.B18.03.00.0054
SHW40.86B.D.04.00.0668
952
Minimum Host Bios
v1.14 build
KPE139AUS or higher
ARE122AUS V1.07
12/14/01
v1.0 build
GFE111AUS or higher
RUKT52AUS v1.08
03/17/03
v1.10
v1.0 build
GGE112AUS or higher
Min v1.01 with build
C9E111AUS
Min v1.05 build level
C2E130DAUS, v1.01
or higher C2E123AUS
− 11/3/06
Version 1.06
(6/7/2001)
Min BIOS v1.0 build
C8E109A, Min v1.01
Build level
C8E110AUS
Min v1.14 build level
ZYE133CAUS,
ZYJT22A
1.04 or later
v1.01 or higher,
ZSE106AUS 9/18/06
v1.0 − ZUE121AUS
(02/21/05)
v1.01 or higher
ZSE106AUS − 9/18/06
v1.01 or higher
Min v1.07 Build
A3E148A, v1.03 or
higher
Min BIOS v1.07 Build
A3E157A
v1.03
v1.0 build ZTE113AUS
or higher
refer to
ibm.com/support
Min BIOS v1.07 build
A3E157A
v1.12
v1.18
v1.01 Build
OYKT13AUS 10/27/03
Minimum Host Bios
Host BIOS
Host BIOS