Table of Contents
Advertisement
Problem
Monitor is hard to read.
Date and time of recording
are not correct.
No indicators displayed in
monitor.
Print date not available.
Date not imprinted on
images even when Print
date is enabled.
Screen for setting time zone
and date is displayed when
camera is turned on.
Camera settings reset.
Camera becomes hot.
Cause/Solution
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• If camera clock has not been set, "Date not set"
indicator flashes when shooting images and
recording movies. Images and movies saved before
clock is set are dated "00/00/0000 00:00" or "01/01/
2012 00:00" respectively. Set the correct time and
date using Time zone and date in the setup
menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
Hide info is selected for Photo info.
Select Show info.
Time zone and date in the setup menu has not
been set.
• The current shooting mode is one that does not
support Print date.
• The date cannot be imprinted on movies.
Clock battery is exhausted; all settings were restored
to their default values.
The camera may become hot when recording movies
or uploading images from an Eye-Fi card for an
extended period of time, or when the camera is used
in a hot area; this is not a malfunction.
A
98, E73
F6
18, 98,
E70
98, E73
18, 98,
E70
98, E75
18, 21
–
F9
Advertisement
Table of Contents
