1. Manuals
  2. Brands
  3. Lightolier Manuals
  4. Lighting Equipment
  5. IS_EG2
  6. Assembly and installation

Lightolier IS_EG2 Assembly And Installation

Lighting systems
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

IS_EG2
Lighting Systems
10"
We reserve the right to change details of design, materials and finish.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IS_EG2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Lightolier IS_EG2

Summary of Contents for Lightolier IS_EG2

  • Page 1 IS_EG2 Lighting Systems 10” We reserve the right to change details of design, materials and finish.
  • Page 2 IS_EG2 Lighting Systems 48” or 96” 48” or 96” JUNCTION BOX (BY OTHERS) CANOPY CANOPY POWER CANOPY Figure 1 POWER CORD #8 SCREWS COVER MALE PLUG 1/4-20 BOLT CABLE GRIPPER POWER CORD FEMALE PLUG Figure 2 HANGING CLIP END-CAP SET SCREW (DO NOT OVER TIGHTEN) 1/4-20 BOLT We reserve the right to change details of design, materials and finish.
  • Page 3 IS_EG2 Lighting Systems Step 1. Installing the Suspension Cables Step 2. Installing the First Fixture Step 3. Installing the Remaining Fixtures Step 4. End of Row We reserve the right to change details of design, materials and finish.
  • Page 4 IS_EG2 Lighting Systems Step 1. Modifying the Unit NOTE: In some instances some of the wires in the fixture are required to remain uncut. (DALI, SHARING DAYLIGHT SENSOR , ETC.) In this case only cut and tap into the hot and neutral wires in the wire harness. POWER CORD 1ST POWER DROP 2ND POWER DROP...

Table of Contents