Technical Details - Ariston AVXXL149 Instruction Booklet

Hide thumbs Also See for AVXXL149:
Table of Contents

Advertisement

Drainage connections
B
A
should not be under water.
! We advise against the use of hose extensions. In case of
absolute need, the extension must have the same diameter
as the original hose and must not exceed 150 cm in length.
Electrical connection
Before plugging the appliance into the mains socket, make
sure that:
• the socket is earthed and in compliance with the
applicable law.
• the socket is able to sustain the appliance's maximum
power load indicated in the Technical Details table (on
the right).
• the supply voltage is included within the values indicated
in the Technical Details table (on the right).
• the socket is compatible with the machines plug. If this
is not the case, replace the socket or the plug.
! The machine should not be installed in an outdoor
environment, not even when the area is sheltered, because
it may be very dangerous to leave it exposed to rain and
thunderstorms.
! When the machine is installed, the mains socket must be
within easy reach and should be connected to a suitable
electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable should never be bent or
dangerously compressed.
! The power supply cable must only be replaced by an
authorised serviceman.
! The company denies all liability if and when these norms
are not respected.
A. Connect the drain
hose, without kinking it, to
a draining duct or a wall
drain fixed at a height
between 65 and 100cm
from the floor.
B. Alternatively, place it
over the edge of a basin,
sink or tub, fastening the
hose supplied to the tap.
The free end of the hose
The first wash cycle
Once the appliance has been installed and before you
use it for the first time, run a wash cycle without detergent
and no laundry, setting the 90°C programme without a
pre-wash cycle.

TECHNICAL DETAILS

Models
AVXXL149
width 59.5 cm
Dimensions
height 85 cm
depth 60 cm
Capacity
from 1 to 7 kg
Electrical
voltage 220 - 240 Volts 50 Hz
connections
absorbed power 1700 - 2100 W
maximum pressure 1 MPa (10 bar)
Water connection
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 53 litres
Spin speed
up to 1400 r.p.m.
Test programmes
programme 4
in compliance with
temperature 60°C
regulation IEC456
performed with a load weighing 7 kg
This appliance conforms to the
following European Community
directives:
72/23/EEC dated 19/02/72 (Low
Voltage) and subsequent amendments
- 89/336/EEC dated 03.05.89
(Electromagnetic Compatibility) and
subsequent amendments
GB
3 3 3 3 3

Advertisement

Table of Contents
loading

Table of Contents