important note before starting Auto Setup
If you have a Video Cassette Recorder or a Satellite receiver connected to your TV please
ensure that they are switched on before automatic tuning begins. In the case of a VCR, insert
a pre-recorded tape and begin playback of your equipment. These measures ensure that all
your external equipment is tuned in during the Auto Setup procedure.
start A.P.S. (Auto Programming System)
When the TV is turned on for the first time, the menu for the language selection
appears on the screen. The message
is written in all language options sequentially in the menu on the screen. By
buttons highlight the language you want to set and press
First time Installation Menu
buttons, select country item you want to set and press
After the First Time Installation is set, the following message appears on the
To start automatic search, select
take about five minutes. To cancel searching, you can press " " button at any time
during the process.
analogue channel search appears on the screen. To continue Auto Program,
first set the language, country and teletext language by using
then press the RED or
After APS is finalized, the programme table will appear on the screen. In the
programme list you will see the programme numbers and names assigned to
For details, please refer to the
Once the TV has found all your local stations, they are then automatically
assigned a programme numberand name, if available from the broadcast.
"Welcome please select your language!"
will appear on screen. By pressing or
to cancel select
process is completed, a message asking for
section of the instruction book.
This process will
First time installation
Set country and continue installation
Do you want to start automatic search?
Searching UHF channels 62. Please wait. This will take a few minutes
PLEASE CHECK ANTENNA CABLE
AUTO. PROGRAMMING SYSTEM
APS is running...
P 03 - C 04