First Time Installation; Media Browser - Hitachi L26HP03U Instructions For Use Manual

Press OK to cancel.
Select Yes by pressing " " or " " button and
press OK to delete all of the channels.

First Time Installation

The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
To install factory settings, highlight "First Time
Installation" menu item and press OK button,
then you will be asked whether or not to delete
the settings. Selecting "Yes" by pressing OK
button while the "Yes" is highlighted will delete
the existing channel table.
Then you will be asked to confi rm for deleting
all channels and settings:
By selecting Yes and pressing the OK button,
the existing channel table will be deleted.
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language
selection appears on the screen at fi rst. By using
" " or " " buttons, select the desired language
option, and press OK button to activate.
"First time installation" OSD will appear on the
screen. By pressing " " or " " buttons, select
the Country you want to set and press OK
button (* only for EU countries).
After the country option is selected, a message
asking for automatic search appears on the
screen:
Press the OK button to start installation. After
search is completed for digital channels, a
message asking whether to search for analogue
channels appears on the screen:
Press the OK button to search for analogue
channels. The following menu appears on the
screen for analogue channel search:
Select your Country, Language and TXT
Language by using " " or " " and " " or " "
buttons. Press OK or RED button to continue. To
cancel, press BLUE button. The following menu
will be displayed during the automatic tuning:
After APS is fi nalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers and
names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via
the program table.

Media Browser

• To display Media Browser window, press
either " M" button on the remote control and
then select Media Browser by pressing " "
or " " button. Press OK button to continue.
Media Browser menu contents (depending
on the contents of your USB drive) will be
displayed.
• Also, when you plug a USB device, the
following screen will be displayed:
English - 31 -