Programme Selection (Direct Access)
Press numeric buttons on the remote control to select
programmes between 0 and 9. The TV will switch
to the selected programme. To select programmes
between, press the numeric buttons consecutively.
When the pressing time is due for the second
numeric button, only the ﬁ rst digit programme will
be displayed. Press directly the programme number
to reselect single digit programmes.
Note: If the background is transparent, on screen texts
will be slightly transparent as well.
First Time Installation
IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the ﬁ rst
When the TV is operated for the ﬁ rst time, installation
wizard will guide you through the process. First,
language selection screen will be displayed:
" or " " buttons to select your language
and press OK button to set selected language and
After selecting the language, "
be displayed, requiring you to set Country, Teletext
Language, Scan Encrypted and Active Antenna
By pressing "
" or " " button, select the country
you want to set and press " " button to highlight
Teletext Language option. Use " " or " " button
to select desired Teletext Language.
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want to
scan coded stations.
After selecting the Scan Encrypted, select
antenna feature (optional) by pressing " " or " "
button. Use " " or " " button to set active antenna
mode as on or off. If an active antenna is connected
to your TV, you can select this option as On (5V).
Antenna power should be Off when standard
antenna is used instead of the active antenna.
and the following message will be displayed on the
To select the "Yes" or "No" option, highlight the item by
using " " or " " buttons and press OK button.
Afterwards, the following OSD will be displayed on
If you select CABLE option, the following screen will
Welcome!" screen will
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When ﬁ nished, press OK button to start
English - 15 -
" button after setting Teletext Language
OK button on the remote control to continue