Lightolier SADDLE CANOPY KIT Instructions For Maintenance Reference

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTION
SHEET NO. 7
lis fixture is intended for installation in accordance with the National Electrical Code and local regulations.
I assure full compliance with local codes and regulations, check with your local electrical inspector before
IS:6063
lstallation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
A1294
Page 1 of 1
SADDLE CANOPY KIT
FORUSEWITH 6000 OR9100 SERIESLIGHTOLIER LIGHTINGTRACKSYSTEM ONLY
rhe Saddle Canopy Mounting Kit mounts to any point along the track for feeding power from an outlet box. Extra Dead End Cover is included
:0 replace LIVE END if desired.
CAUTION:
TURN OFF POWER
AT FUSEBOX BEFOREINSTALLING TRACK. INSTRUCTIONS
FOR GROUNDING MUST
BE
FOLLOWED.FAILURETO DO SO MAY RESULTIN A HAZARDOUS CONDITION.
1, Attach CROSSBAR to OUTLET BOX as shown in Fig. 1.
2, Mount track to ceiling as shown in Instruction Sheet 6020 or
CENTERLINE
OUTLETBOX
9100 bringing lead wires (#1 2 ga.) from OUTLET BOX
down
(FLUSHWITH CEILING)
either side of track.
oEAO END
3. Insert FITTING into TRACK (see Fig. 2) with LOCKING LEVER on
COVER
same side of track as BEAD.
\
4, Rotate FITTING 90" clockwise until LOCKING LEVER snaps into
place (see Fig. 2).
5. Make wiring connections: black to black, white to white, green
TRACK
or bare wire to grounding terminal or ground wire in OUTLET
BOX (see Fig. 3).
FITTING
I
6. Insert wiring connections into OUTLET BOX (see Fig, 3).
7. Place CANOPY over FITTING, lineup
holes in CANOPY with
threaded holes in CROSSBAR, and fasten together with screws
CANOPY /"
(included). Make certain that wires do not interfere with proper
CANOPY MOUNTING —.!
seating of CANOPY.
SCREW
B. LIVE
END maybe removed and replaced with DEAD END COVER
(included).
FIG. 1
CROSSBAR
,Lo:pR& ~'
LOCKING
LEVER
CANOPY
.!
I FIG. 3
1- I
C: H TC>L I E 1? :::::::iN:=:f..:
FIG.
2