Table of Contents
Advertisement
AVD-505
7.2 DISASSEMBLY
- Removing the Case Section
1. Remove the four screws.
2. Remove the three stoppers indicated by the arrows,
and lift the Case Section
3. Disconnect the connectors at the three locations and
remove the Case Section.
Note:When assembling, be careful not to catch the LCD
Panel flexible connector between the Grille Assy
and the Case Section.Remove the Case by either
pushing on the left or right of center of the side of
it.
- Removing LCD Unit
1. Disconnect the two connectors.
2. Upright the tabs in four places indicated with arrows.
3. Remove the LCD Unit.
- Removing the Back Light Unit
1. Remove the six stoppers indicate the arrows, and
then remove the Back Light Unit.
28
Flexible Connector
Case Section
Grille Assy
LCD Unit
Back Light Unit
Advertisement
Table of Contents
