Telephone Circuits; Wiring Phone Jacks - Fire-Lite 411UDAC Installation, Programming, Troubleshooting And Operating Instruction Manual

Telephone Circuits

2.6 Telephone Circuits
Provision to connect two independent telephone lines is available via two telephone jacks labeled PH1 (Primary)
and PH2 (Secondary). Telephone line control/command is possible via double line seizure as well as usage of an
RJ31X style interconnection. (RJ31X jacks must be ordered separately).
CAUTION: It is critical that the 411UDAC be located as the first device on the incoming telephone circuit to
properly function.

Wiring Phone Jacks

FIGURE 2-11:
411UDAC
28
(Primary Lines)
Incoming Telco
Phone Lines
Green Wire
Tip
Red Wire
Ring
Primary Phone Line PH1
411UDAC
Tip
Ring
Ring
To Premises Phone
Tip
Note: Shorting bars
inside RJ31X Jack
removed during
male plug insertion
7 foot Cable (MCBL-7)
Not supplied - Order
Separately
(2 required)
Secondary Phone Line PH2
Male Plug
Connectors
Female
Connectors
Document #51073 Rev. D 12/09/2008
(Secondary Lines)
Incoming Telco
Phone Lines
Green Wire
Red Wire
Ring
To Premises Phone
Tip
P/N 51073:D