Hdmi Control Of Cec Devices; Enabling Hdmi Control Of Cec Devices - Mitsubishi Electric 3D DLP 642 Series Owner's Manual

HDMI C ontrol of CEC Devices
3
Many newer HDMI devices have a feature called
Consumer Electronics Control (CEC) or HDMI Control.
HDMI Control allows one device, such as the TV, to
control other devices, such as an A/V receiver or disc
player. Use of CEC is optional.
Each manufacturer chooses which CEC functions to
support so it is difficult to predict which devices and
features are compatible with Mitsubishi's HDMI Control.
You may find that CEC functions for a specific device are
limited.
To use HDMI Control, you must enable it both in
the TV and in the device.
• In the TV. Enable HDMI control from the New
Device Found screen or from the Inputs > HDMI
Control menu.
• In the Device. Most devices with HDMI CEC com-
patibility let you turn it on or off in the device menus,
where it is typically listed as "HDMI Control."
Enabling HD MI Control
of CEC Devices
To ensure proper detection
• Power on HDMI devices before connecting
them to the TV.
• Connect and set up HDMI devices one at a
time.
1.
Power on the device and allow it to complete the
power-on sequence (boot up). Stop any playback.
2.
Connect the device to one of the TV's HDMI inputs.
3.
When the TV detects the connection, the New
Device Found screen will appear.
Note: See "If the New Device Found Screen Has No
HDMI Control Option" on this page if an HDMI
Control option is not offered.
New Device Found screen with HDMI Control option.
This screen displays only if the device's HDMI Control is
enabled.
4.
If prompted for a name, high-
light a name for the device
and press ENTER to add a
check. The device itself may
later override the name you
assign.
5.
Highlight On and press ENTER
to add a check.
6.
Highlight EXIT and press ENTER to close the New
Device Found screen.
Note: At any time after completing Auto Input Sens-
ing, you can set the TV's HDMI control on or off
in the Inputs > HDMI Control menu.
If the New Device Found Screen
Has No HDMI Co ntrol Option
If the New Device Found screen shows no option for
HDMI Control, one of these conditions applies:
• HDMI Control is turned off in the menus of the
new device
Action:
a. Highlight EXIT and press ENTER to close the
New Device Found screen.
b. Display the device's setup menus and enable
the device's CEC capabilities.
c. Wait for the TV's New Device Found screen
to appear again.
d. If the New Device Found screen does not
appear, power off the device. Power on the
device and wait for the New Device Found
screen to display with the HDMI Control
option.
• The HDMI cable cannot support CEC
Action:
Upgrade your HDMI cable to one that supports
CEC.
• The device does not have CEC compatibility
Action:
Control the device with its own remote control or
program the TV's remote control to operate the
device.
For assistance call 1(800) 332-2119
25