Basic Operation; Teletext (Analogue) - Hitachi 22LD5550U User Manual

Basic Operation

Channel selection
With the numbered buttons.
Example:
• No. 2: Press 0 and within 2 seconds, press 2.
• No. 29: Press 2 and within 2 seconds, press 9.
Press P + or – to change up or down a channel.
This takes approx. 2 seconds. If the auto search
only stored 5 stations, only these 5 will appear.
Skipped channels will not appear (see P.12).
CH LIST
The CH LIST shows a list of all receivable
programmes. They are located in channels 1 to 99.
Press CH LIST to display the CH LIST.
Press or to select the desired channel.
Press CH LIST to display the selected channel.
Press EXIT to exit.
QuickView
button allows you to go back to the last
selected channel.
Volume adjusting
Press + or – to adjust the volume.
MUTE
Press . The sound will be cut off. MUTE will
appear for approx. 4 seconds.
The muting can be released by pressing
or + or –.
Information display
In the analogue TV mode: Press . Channel
number and picture size setting will appear for
approx. 4 seconds.
In the digital TV mode: Press . The program
information will appear (see 'Channel banner' on
page 22).
SLEEP TIMER
To set the sleep timer press
minutes until shut-off will appear. Each time you
press the SLEEP time shown will change. When
the displayed time runs out, the unit will switch to
standby.
To cancel the sleep timer:
Press repeatedly until '0' appears.
Note:
• SLEEP TIMER can also be set in the SLEEP TIMER-
menu (see p.17).
Note:
• If the built-in tuner does not receive anything (e.g. if
no antenna is connected) during TV-operation, then
the TV-unit will change to standby after approx. 15
minutes.
again
. SLEEP and the

Teletext (analogue)

Teletext is sent page by page. This unit is able to
automatically store up to 256 pages, but they can
only be accessed once they have been stored.
This can take a few moments.
Fastext/TOPtext
The Fastext/TOPtext is teletext with a special
directory.
On the lower part of the screen there are four
different coloured fi elds (red, green, yellow and
blue). These fi elds lead directly to the pages
shown within. The coloured buttons on the
remote control correspond to the coloured fi elds.
Press the appropriate coloured button in order to
activate the desired colour fi eld.
Switch on / off Teletext
Teletext is not transmitted by all channels.
Select a channel that shows teletext.
Press . You will now see a teletext page. (If
"100" is shown without any text information, it
may mean that the channel you have selected
does not support teletext.)
Press again. The TV-screen will be split into
two and both Teletext information and actual
broadcast will be displayed at the same time.
Press again in order to switch off teletext.
Press again in order to switch on teletext again.
The last page which was stored is now shown.
Note:
• You cannot select any other channels as long as
teletext is switched on. Switch teletext off when you
want to switch over to another channel.
Select Page
Press P + or – until the page you desire appears.
Or ... enter the requested page number by using
the 10 Number Buttons.
And if you mistype something, just enter the
complete 3-digit wrong page number then enter
the desired number again. Or ... press one of the
coloured teletext buttons so that a page from
Fastext/TOPtext is shown.
TELETEXT
TELETEXT
13