Table of Contents
Advertisement
Setting up the DVD Player
Connections
•
Do not place the unit on amplifiers or equipment that may become hot. The heat can damage the unit.
•
Do not connect through the video cassette recorder. Due to copy guard protection, the picture may not display
properly.
•
Turn off all equipment before connection and read the appropriate operating instructions.
•
Connect the terminals of the same colour.
•
Connect the AC mains lead last.
Stereo System
For EU
model
TO WALL OUTLET
For UK
model
CVBS - Composite Video Connection
1.
Use the composite video cable (yellow) to
connect the DVD player's CVBS socket to
the VIDEO INPUT socket (which can be
labelled as A/V IN, VIDEO IN, COMPOSITE
or BASEBAND) on the rear panel of the TV.
2.
To hear the audio sound of your DVD
player through your TV, connect the audio
cable (white and yellow) to AUDIO OUT (L/
R) sockets of the DVD player to the
corresponding AUDIO IN sockets on the
TV.
YPbPr - Component Video Connection
With a Progressive Scan television and using
YPbPr video connection, you can view your DVD
video with Progressive Scan Video Quality.
1.
Use the component video cables (red/blue/
green) to connect the DVD player's YPbPr
sockets respectively. YPbPr video cables
are not supplied with this package.
2.
To hear the audio sound of your DVD
player through your TV, connect the audio
cable (white and yellow) to AUDIO OUT (L/
R) sockets of the DVD player to the
corresponding AUDIO IN sockets on the
TV.
NOTE: Proceed to Progressive Scan SetUp.
GB-12
AUDIO
IN
Component cable
(not included)
CO
110-240V~
50/60Hz
Y
Audio Cable
TV
VIDEO IN
Y
(Audio)Red
White
(Video)Yellow
Red
Blue
Green
Coaxial Audio Cable (not included)
SCART Cable (not included)
Y
RF IN
SCART IN
SCART - SCART Video and Audio Connection
1.
Use the SCART cable and connect between
DVD player's SCART OUT and TV's SCART
IN. SCART cable is not supplied with this
package.
2.
If your DVD player will not be connected to
the stereo system or AV receiver to hear
better sound quality, SCART connection is
sufficient for both audio and video
connections between the DVD player and TV.
Stereo System Audio Connection
1.
Select one of the video connections (CVBS
Video IN or Component Video IN) depending
on your TV.
2.
Use the audio cables (white/red) to connect
AUDIO OUT (L/R) socket of the DVD player to
AUDIO IN on the Stereo System.
Digital AV Receiver Connection
1.
Select one of the video connections (CVBS
Video IN or Component Video IN) depending
on your TV.
2.
Use the coaxial cable to connect COAXIAL
socket of the DVD player to DIGITAL AUDIO
IN socket of the Audio Receiver.
Audio Receiver
RF
Antenna
OR
Advertisement
Table of Contents
