Image Menu; Ver Scan - Hitachi MP-J1 User Manual

IMAGE Menu

IMAGE Menu
From the IMAGE menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons, and press
the ► cursor button or ENTER button to execute the item.
Then perform it according to the following table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
(continued on next page)
6
Using the ▲/▼ buttons switches the mode for aspect ratio.
For a PC signal or a signal from the USB STORAGE
NORMAL ó 4:3 ó 16:9 ó SMALL
For a Video signal, s-video signal or component video signal
4:3 ó 16:9 ó 14:9 ó SMALL
For no signal
4:3 (fixed)
• This item can be selected only for a proper signal.
• The NORMAL mode keeps the original aspect ratio setting.
• Performing the automatic adjustment initializes the aspect ratio setting.
Using the ▲/▼ buttons adjusts the over-scan ratio.
Large (It reduces picture) ó Small (It magnifies picture)
• This item can be selected only for a video, s-video and component video signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Using the ▲/▼ buttons adjusts the vertical position.
Up ó Down
• This item cannot be selected for a signal from the USB STORAGE port.
• Over-adjusting the vertical position may cause noise to appear on the screen. If this
occurs please reset the vertical position to the default setting. Pressing the RESET button
when the V POSITION is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal, the range of this adjustment depends on the
OVER SCAN (above) setting. It is not possible to adjust when the OVER
SCAN is set to 10.
Using the ▲/▼ buttons adjusts the horizontal position.
Left ó Right
• This item cannot be selected for a signal from the USB STORAGE port.
• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
occurs please reset the horizontal position to the default setting. Pressing the RESET
button when the H POSITION is selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal, the range of this adjustment depends on the
OVER SCAN (above) setting. It is not possible to adjust when the OVER
SCAN is set to 10.
Description