Table of Contents
Advertisement
5. KB side cover (L) is adjusted to the upper part as
well as KB side cover (R), the minus clock driver
removes hook (C-1) in the hook position from the
space with the bottom case, rotates to the key-
board side, and detaches.
Hook (C-1)
KB Side Cover (L)
Hook (C-2)
LCD Unit
6. The both sides tape pasted to the keyboard bottom
with the spatula is inserted in order of the arrow and
then peel off. It is start-up from the LCD side and
turns inside out on the top case.
The KBD FPC WP sheet is peeld off, FFC (key-
board) is removed from connector (CN25) and
(CN24), and then remove the keyboard.
Do not damage the spatula ahead and move a top case in the
direction of the arrow in
order.
KBD FPC WP Sheet
Keyboard
Both Sides Tape
Note:
KBD-FPC sheet cannot be recycled. Please use new
parts.
9.2.4. Removing the Top Case
Preparation : perform the section 9.2.1., 9.2.3.
first.
1. Remove the 2 screws (E) and 2 foot rubber backs.
Screw (E) : XTB26+10GFN (N12)
2. Remove the 5 screws (F).
Hook (C-1)
Screw (F) : DXHM0057ZA (N5)
3. Remove the 2 screws (G).
Screw (G) : DXHM0049ZA (N3)
Hook (C-2)
4. Remove the 1 screw (H) and 1 screw (I ).
Screw (H) : DXQT2+D4FNL (N7)
Screw (I ) : DXQT2+E10FNL (N8)
Bottom Case
Screw (G)
Screw (F)
Screw (F)
Screw (I)
Spatula
5. Operate the LCD knob and open the LCD Unit to an
angle of 90 degrees or more.
6. The hook 2 places of the disk side cover are re-
moved, and detaches forward while rotating in the
direction of the upper surface.
7. The disk cover lock is mechanically released, and
the disk cover is opened.
CN24
CN25
Back Side
26
Foot Rubber Back
Screw (E)
Screw (G)
Screw (F)
Screw (H)
Screw (F)
LCD Unit
Disk Cover
Mechanical Release Lever
Foot Rubber Back
Screw (E)
Screw (F)
Hook (D)
Disk Side Cover
Advertisement
Table of Contents
