2.2.13. Removing the LCD Unit
Preparation : perform the section 2.2.1. to 2.2.3. first.
1. Remove the 2 screws (M).
Screw(M):DXQT26+D5FNL(N14)
2. Remove the LCD cable from the connector (CN11) of the
main board.
3. Remove the inverter cable from the connector (CN10)
4. Remove the touch panel cable from connector (CN24).
Screw(M)
LCD Cable
CN10
CN11
2.2.14. Removing the Hinge Cover
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
first.
1. Remove the 2 screws (Q) and then remove the hinge cover
(L,R).
Screw(Q):DRHM0076ZA(N3)
Screw(Q)
Hinge Cover(L)
2. Remove the 2 screws (R).
Screw (R):DRHM0076ZA(N3)
Screw(R)
Screw(M)
CN24
LCD Unit
Screw(Q)
Hinge Cover(R)
LCD Unit
Screw(R)
2.2.15. Removing the LCD Unit and the
LCD Rear
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
to 2. 2. 14. first.
1. Separate the LCD front and the LCD rear.
2. Remove the hinge (L).
Hook Position
HInge(L)
LCD Front
LCD Rear
2.2.16. Remove the Inverter
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
to 2. 2. 15. first.
1. Remove the LCD cable from the inverter.
2. Peel off the conductive cloth(LCD cable) from the inverter.
3. Remove the inverter with inverter box.
LCD Front
LCD High voltage
2pin Wire Rod
Inverter Box
Tape
2-8
LCD Unit
Hinge(R)
LCD Hook
Conductive Cloth
(LCD Cable)
LCD Cable