Dial Plan Parameters - Linksys SPA922 Administrator's Manual

Parameter
DTMF Process AVT Select yes to process RTP DTMF events. Otherwise, select no. If
this parameter is set to no, the AVT payload type is not included
in outbound SDP.
Defaults to yes.
Silence Supp Enable To enable silence suppression so that silent audio frames are not
transmitted, select yes. Otherwise, select no. See
Voice Quality" section on page 39
Defaults to no.
DTMF Tx Method Select the method to transmit DTMF signals to the far end: InBand,
audio video transport (AVT), INFO, Auto, InBand+INFO, or AVT+INFO.
InBand sends DTMF using the audio path. AVT sends DTMF as AVT
events. INFO uses the SIP INFO method. Auto uses InBand or AVT
based on the outcome of codec negotiation.
Defaults to Auto.

Dial Plan Parameters

You can configure a dial plan with three interdigit timers:
• Initial timeout (T)—Handset off hook; no digit pressed yet.
• Long timeout (L)—One or more digits pressed, more digits needed to reach a valid
number (as per the dial plan).
• Short timeout (S)—Current dialed number is valid, but more digits would also lead to a
valid number.
Linksys SPA9x2 Phone Administration Guide
Customizing SPA9x2 Extensions
Description
Dial Plan Parameters
"Factors Affecting
.
105