Transmitter Programming; Alarm Feature Programming - Marksman Extreme Series X9 Installation Manual

Programming the Transmitter
Programming the Remote Transmitter
(Includes the Standard Type and LCD Transmitter Type)
Note: This mode will only retain the last 4 remote transmitters programmed. If the transmitter memory is
exceeded, the security system will start deleting transmitters from memory in chronological order.
Step 1
OF F
ON
With the ignition switch in the OFF position, Turn the
ignition switch On - Off - On - Off - On
Step 3
4
4
SAVE
Press the "Lock" button on the first
transmitter until you hear a confirmation
chirp/beep. The transmitter is now
coded into the system.
Alarm Feature Programming (Group 1)
Examine the 3 different feature charts enclosed and decide which feature will get changed. Circling the feature to
be changed will make the programming process much easier to perform.
Step 1
OFF
ON
With the ignition switch in the OFF position, Turn the
ignition switch On - Off - On - Off - On - Off
3X
Before 15 seconds has passed, push and release the
valet switch 3 times holding the button down on the
3rd press. Wait until a long chirp or beep is heard.
Release the button. You are now in transmitter
programming mode.
Step 4
4
4
SAVE
Repeat for each additional
transmitter.
3X
Before 15 seconds has passed, push and release the
valet switch 2 times holding the button down on the
2nd press. Wait until 1 short and 1 long chirp or beep
is heard. Release the button. You are now in "Alarm
Feature Programming (Group 1)" mode
Step 1
2X + 1X (Hold)
Step 5
Exit Programming
O F F
When finished, either turn off the
ignition key or wait for 15 seconds
to get out of transmitter programming
mode. You will hear 3 long chirps/
beeps to indicate you are out of the
transmitter programming mode.
Step 2
1X + 1X (Hold)
17