Operation Procedure - Magic Chef MCD1110WB Operation And Cooking Manual

OPERATION PROCEDURE

This section includes useful information about oven operation.
1 Plug power supply cord into a standard 3-pronged
15 Amp, 120V AC 60Hz power outlet.
2
After placing the food in a suitable container,
open the oven door and put it on the glass tray.
The glass tray and roller guide must always be in
place during cooking.
3
Close the door. Make sure that it is firmly closed.
4
The oven light is on when the microwave oven is
operating.
The oven door can be opened at any time during
5
operation by pulling the handle of door. The oven
will automatically shut off.
6 Each time a pad is touched, a BEEP will sound to
acknowledge the touch.
The oven automatically cooks on full power
7
unless set to a lower power level.
8
The display will show " : 0" when the oven is
plugged in.
WATTAGE OUTPUT CHART
•
The power-level is set by touching the Micro Power pad. The chart shows the display, the power level and the
percentage of power.
Touch the Micro Power pad
once
twice
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times
11 times
19 Time clock returns to the present time when the
cooking time ends.
10
When the STOP/CLEAR pad is touched during the
oven operation, the oven stops cooking and all
information retained. To erase all information(except
the present time), touch the STOP/CLEAR pad
once more. If the oven door is opened during the
oven operation, all information is retained.
If the START pad is touched and the oven does not
11
operate, check the area between the door and door
seal for obstructions and make sure the door is
closed securely. The oven will not start cooking until
the door is completely closed or the program has
been reset.
Make sure the oven is properly installed and
plugged into the electrical outlet.
Power level (Display)
P-HI
P-90
P-80
P-70
P-60
P-50
P-40
P-30
P-20
P-10
P-00
8
Approximate Percentage of Power
100%
90%
80%
70%
60%
50%
40%
30%
20%
10%
0%