Removing The Protective Materials; Setting Up The Printer - Epson STYLUS COLOR II Setup Manual

Removing the Protective Materials

You must remove all protective materials packed around and
inside your printer before you set it up and turn on the power.
Save all packaging and protective materials in case you need to
ship the printer in the future. It should always be transported
in its original packaging or equivalent materials.
First remove the transportation screw securing the print head
to the carriage. Flip down the output tray and lift up the
printer cover. Loosen the transportation screw by turning its
handle counterclockwise; then lift it off the carriage.
Save the screw so you can reinstall it if you transport your
printer later. (See Chapter 3 of the Reference Guide for more
information on transporting the printer.)
Follow the directions on the Notice Sheet packed with the
printer to remove the rest of the materials.

Setting Up the Printer

The following installation procedures describe how to set up
and test the printer before you connect it to your Macintosh.
Refer to the illustrations on the inside front cover to identify
the main components while setting up the printer.
Installing the Printer
1-3