Table of Contents
Advertisement
The Print Head
To understand how the graphics mode works, you need to know a
little about the print head on the HomeWriter-10.
The print head has nine pins or wires mounted vertically. Each time
a pin is fired, it strikes the inked ribbon and presses it against the paper
to produce a dot. This dot is about 1/72nd of an inch in diameter,
depending upon the age of the ribbon and the type of paper used.
As the print head moves horizontally across the page, these pins are
fired time after time in different patterns to produce letters, symbols,
or graphics.
In the graphics mode, the HomeWriter- prints one column of pins
for each CHR$ number it receives, and it uses only the top seven pins.
Therefore, your graphics program must send CHR$ numbers for
dot patterns, one number for each column in a line. For each of those
columns, 1/60th of an inch apart, the print head prints the pattern of
dots you have specified.
To print figures taller than seven dots, the print head makes more
than one pass. It prints one line, then advances the paper and prints
another, just as it does with text.
To keep the print head from leaving gaps between the graphics lines
as it does between the text lines, the line spacing changes automati-
cally to eliminate the space between lines. This change in line spacing
enables the HomeWriter- to print finely detailed graphic images
that give no indication that they are made up of separate lines, each
less than l/10th of an inch wide.
Graphics Mode
The code that turns on the graphics mode is CHR$(8). After you
send this code, you send numbers that tell the HomeWriter- what
dot patterns you want the print head to print. The next section
explains what numbers to use.
27
Advertisement
Table of Contents
