Eclipse AVN5495 Reference Manual page 26

Introduction
● The display can still be opened when it has been tilted. When closed again, it
will return to its tilted position.
● If the display is in an adjusted angle position when the vehicle ignition is turned
ATTENTION
off, the display will automatically return to its original position (0°). If the ignition
switch is then turned to ACC or ON, the display will resume the adjusted angle
position.
●
Be careful not to pinch your fingers or other objects when adjusting the angle of
the display. This could cause an injury or damage to the display.
●
Do not insert discs into the gap created at the top of the unit when the display is
Caution
tilted. Otherwise, the media or unit may be damaged.
● Observe the following cautions when adjusting the angle of the display.
<Automatic transmission vehicles>
When setting the tilt position, choose an angle that does not interfere with opera-
tion of the shift lever in the "P", "R" or "N" lever positions. (If there is interference
with the shift lever in these operating positions, do not set a tilt position.)
<Manual transmission vehicles>
When setting the tilt position, choose an angle that does not interfere with opera-
tion of the shift lever in the 1, 3, 5 or
do not set a tilt position.)
lever positions. (If there is interference,
26