Part Names And Functions; How To Connect - Elmo CCD Color Video Camera TNC4604 Instruction Manual

PART NAMES AND FUNCTIONS

3
1
60 (2.4)
2
Lens mount
1
Mount a CS-mount lens.
2 Camera mount
For mounting a camera on wall, housing, etc.
(1/4"-20UNC thread)
Focusing dial
3
For fine-adjustment of the lens back-focus.
4 IRIS terminal
Connect when an automatic iris lens is used.
5
VIDEO OUT terminal
Connect to a monitor TV, etc.
(BNC connector)
6 AC power terminal
Connect this to the AC24V 60Hz or DC12V
power supply.
1. Before connection, make sure that power of all units are OFF and cords are unplugged.
2. Mount a lens onto the camera. Refer to "HOW TO USE" for usable lens.
3. Connect video terminal of the camera and the video input terminal of a monitor TV, etc. with a
75Ω coaxial cable.
4. Connect the power terminal of the camera to a power supply.
Caution: Installation should be made by a qualified service personnel and should conform to all
local codes.
Lens, coaxial cable for video signal and power supply are not supplied with a camera.
4
90 (3.5)

HOW TO CONNECT

- 2 -
All dimensions in mm (inch)
8
7
+ +
1 2
+
-
7
Ground terminal
Connect this to the ground wire of the
power supply cord.
8 Camera control switches
Refer to "CAMERA CONTROLS" on
page 4.
5
6
+
DC12V
-
AC24V