Table of Contents
Advertisement
Settng Up the Scanner
Follow these steps to set up the scanner:
1.
Take the scanner out of its box and place it on a flat, stable
surface with the rear panel facing you.
2.
Remove the tape securing the scanner cover and pull out
any packing material from underneath the cover.
3.
Turn off your computer, scanner, and any other peripheral
devices. The scanner is turned off when the 0 end of the
power switch on the rear panel is pressed down.
4.
Connect the 25-pin end of the parallel cable to the parallel
port on your computer; then tighten the screws on the
connector.
5.
Connect the other end of the cable to the parallel interface on
the side of the scanner and fasten it with the wire clamps.
6 Getting Started
Caution:
Be sure that your computer, scanner, and any other
peripheral devices are turned off before you plug in any
cables.
Advertisement
Table of Contents
