Removing The Transformer - Epson ActionPrinter 3000 LQ-200 Service Manual

Removing the transformer

Remove the upper case as described earlier in this chapter.
1.
Disconnect connector CNl on the PEBFIL-II board. (CNl connects the
2.
transformer to the PEBFIL-II board.)
Disconnect connector CNlO on the CO64 MAIN board. (CNlO connects the
3.
transformer to the CO64 MAIN board.)
Remove the CB(0) (M4
4.
terminal.
Remove the four CBB (M4
5.
secure the transformer. Then remove the transformer.
LQ-200/AP3000
8) screw that secures the transformer ground
x
12) screws and the CB(0) 0!I4
x
Figure 3-7. Removing the Transformer
Disassembly and Assembly
8) screw that
x
3-13