Selecting Phase (Non-Fader Phase); Adjusting Frequency Filtering Settings (Low Pass Filter For Sub-Woofer Output); Setting The Loudness Mode (Loudness); Adjusting The Svc (Source Volume Control) - Eclipse AVN4430 Owner's Manual

■ Selecting
phase
PHASE)
The merger of sound between the front and
rear speakers and the woofer can be
improved by selecting the phase. Switch the
phase which lets the speakers combine
without any disharmony.
● To the right:
NORMAL
Make the output timing of the front/rear
speakers and the woofer the same.
To the left:
REVERSE
Change the phase of the output timing of
the front/rear speakers and the woofer.
■ Adjusting
frequency
settings (Low Pass Filter for Sub-
Woofer output)
Frequency filtering settings can be adjusted.
● To the right:
LPF ON
Only allow lower frequencies (low range)
through.
To the left:
LPF OFF
Allow all frequencies through regardless if
the frequencies are low or high.
33
■ Setting
(NON-FADER
Accentuate low and high frequencies when
the volume is low.
When
deficiency in the high sounds is compensated
for.
● To the right:
■ Adjusting
In this mode you can set the volume level for
filtering
each audio source, taking the FM radio
volume level as the reference level.
(The volume level of the audio source you are
currently listening to is adjusted.)
● To the right:
the loudness
(LOUDNESS)
loudness is
Turns ON.
To the left:
Turns OFF.
the
Volume Control)
IMPORTANT
If the DVD sound level is too low, adjust the
SVC for it.
Increases the sound level of current audio
source.
To the left:
Decreases the sound level of current audio
source.
mode
ON, the apparent
SVC (Source
33