Automatic Icemaker; Storage Drawers - GE GTZ18GCESS Owner's Manual & Installation Instructions

About the storage drawers.
Not all features are on all models.
About storage drawer and cover removal.
Not all features are on all models.
About the automatic icemaker
A newly-installed refrigerator may take 12–24 hours to begin making ice.
Icemaker
OFF
ON
Feeler Arm
Power Switch
Feeler Arm
in the STOP
Feeler Arm in the
ON
Snacks Drawer
The snacks drawer can be
moved to the most useful
location for your family's
needs.
Adjustable Humidity Drawer
Slide the control all the way to the
HIGH setting to provide high humidity
recommended for most vegetables.
Drawer and Cover Removal
Drawers can be removed easily by grasping
the sides and lifting up slightly while pulling
drawers past the stop location.
Twin Drawer Shelf
To remove:
Remove the drawers.
Reach in, push the front of glass cover up,
and at the same time, pull it forward as far
as it will come.
Tilt it and take it out. Avoid cleaning the cold
glass cover with hot water because the extreme
the glass cover before you take out the
drawer frame.)

Automatic Icemaker

The icemaker will produce approximately
70-100 cubes. in a 24-hour period, depending
on the freezer compartment temperature, room
temperature, number of door openings and other
use conditions.
If the refrigerator is operated before the water
connection is made to the icemaker, set the
switch OFF or move the feeler arm to the STOP
When the refrigerator has been connected to the
water supply, set the switch ON position or move
the feeler arm to the ON
15°F. A newly-installed refrigerator may take 12 to
24 hours to begin making ice cubes.
Once the icemaker starts to make ice, it may take
temperature settings and number of door openings.
Fruit and Vegetable Drawers
Excess water that may
accumulate in the bottom of the
drawers should be emptied and
the drawers wiped dry.
Slide the control all the way to the LOW
setting to provide lower humidity levels
recommended for most fruits.
To remove the cover,
pull it forward, tilt it and take it out.
back, pull it forward, tilt it and take it out.
To replace:
Lower the frame until it rests on the
supports at each side and back.
Replace the glass cover, pushing its rear
gently lowering the front into place.
Replace the drawers.
You will hear a buzzing sound each time the
the water line to clear.
Be sure nothing interferes with the sweep of the
feeler arm.
icemaker will stop producing ice.
It is normal for several cubes to be joined
together.
If ice is not used frequently, old ice cubes will
become cloudy, taste stale, shrink or fuse together.
Icemaker accessory kit:
If your refrigerator did not already come equipped
with an automatic icemaker, an icemaker
accessory kit is available at extra cost.
icemaker kit needed for your model.
GEAppliances.com
5