GE GTZ18GCESS Owner's Manual & Installation Instructions page 14

2
REVERSING THE DOOR SWING
REVERSING THE DOOR HANDLES
5
5.4 Transfer Freezer Door Handle
5.4.1 Remove the screw
holding the handle
to the top of the
door and the two
screws holding the
handle to the bottom
of the door.
5.4.2 Remove the handle.
5.4.3 Remove the screw from the
right top edge of the door
and insert it into the handle
screw hole on the left side.
5.4.4 Transfer the door stop as shown in preceding
section 5.2.
5.4.5 Attach the handle to the
right edge of the door with
screws at top and bottom,
using bottom holes vacated
by removal of the door stop
screws.
RE-HANGING THE DOORS
6
6.1 Re-hang the fresh food door
6.1.1 Lower the fresh food door onto the
bottom hinge pin. Be sure the washer
is in place on the pin.
Hinge
Bracket
Installation Instructions
(CONT.)
Top
TOP
Bottom
BOTTOM
Plastic
Washer
14
(CONT.)
RE-HANGING THE DOORS
6
6.1.2 Insert the pin on the center hinge into the socket in the
top of the door. Place the spacer, then the washer, on
the hinge pin.
NOTE: The center hinge must
be turned over as shown when
mounted on the left side.
6.1.3 Tilt the door toward the cabinet. As the door is brought
into position, slide the hinge under the head of the screw
which earlier had been partly driven into the outermost
hole. Insert the remaining screw, then tighten both
screws securely.
6.2 Re-hang the freezer door
6.2.1 Lower the freezer door
onto the center
hinge pin. Be sure
the washer and
spacer are in place
on the pin.
6.2.2 Tilt the door toward the cabinet, lifting the top hinge so
6.2.3. Make sure the door is slightly above the top of the
cabinet and the gap between the doors is even
across the front. Tighten the top hinge screws. Do not
overtighten these screws–tighten them until they are
just snug, then turn them another one-half turn.
(CONT.)
Hinge Pin
Plastic Washer
and Spacer
Center Hinge
Pin
Plastic Washer
and Spacer