Advertisement
INSTALLATION INSTRUCTIONS
IMPORTANT! Leave the fan in the carton until you are ready to hang the fan.
CROSSbAR
mOUNTINg
bRACKET
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you
wish to place your Casablanca fan, an approved ceiling
fixture outlet box must be installed and wired.
Warning: To reduce the risk of fire, electrical
shock, or personal injury, mount to outlet box
marked acceptable for ceiling fan support using
the mounting hardware provided with the outlet
box. Using Existing Ceiling Fixture Outlet Box
CROSSBAR MOUNTING BRACKET INSTALLATION
Proceed with installation as follows:
Step 1. To install the crossbar mounting bracket, route
the outlet box wires along side of the crossbar mounting
bracket. Attach the crossbar mounting bracket to the
outlet box with the set of two round-head screws and
washers. Use caution when installing the screws and
washers. Do not pinch the outlet box wires in the wash-
ers. Tighten the screws firmly by hand only, being careful
not to bend the bracket by over tightening.
CAUTION: To reduce the risk
of personal injury, use only the
mounting hardware provided
with the approved outlet box to
install the crossbar mounting
bracket.
Step 2. To install the lag screw, slide the remaining
washer onto the lag screw. Pass the lag screw through
the center hole in the crossbar mounting bracket. Se-
cure the lag screw into the guide hole, tightening until
the ceiling fixture outlet box is firmly mounted to the
support beam.
CEILING HARDWARE
WIRE NUT (4)
LAg SCREW AND WASHER
GETTING STARTED
M
odena
(1)
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked 'Approved for ceiling fan mounting'.
If it is not, a new box must be installed.
JOIST
CEILINg
WIRINg
gREEN
gROUND
WIRE
II
®
1" x 8-32 ROUND
HEAD SCREWS (2)
fLAT WASHER (2)
CEILINg fIxTURE
OUTLET bOx
(CEILINg fAN
RATED)
CROSSbAR
mOUNTINg
bRACKET
(RIDgE SIDE
DOWN)
WASHERS
(2)
1" x 8-32
ROUND-HEAD
SCREWS (2)
LAg SCREW
AND
WASHER (1)
3
Advertisement
